Icing Wind Tunnel CWT-1

Cold Wind Tunnel Scheme

The von Karman Institute for Fluid Dynamics has recently converted its Cold Wind Tunnel CWT-1 into an icing wind tunnel. This facility was designed in the past to study the motion of films of anti-icing fluids applied to aircraft wings during a simulated take-off. Built out of wood and epoxy-fiberglass composite, it is internally insulated with a 5 cm layer of polystyrene foam covered by a smooth epoxy lining. It runs in a closed-loop configuration and it has a 1.6 m long test section with a 0.1 m x 0.3 m cross section. A larger test section of 0.3mx0.3m is under construction to be installed in the return loop.

In order to provide optical access, both the top and bottom walls of the test section are made of double glazing. The large dimensions of the window in the test section allow installing several optical devices simultaneously. The CWT-1 is driven by a 12kW motor and it can achieve maximum flow velocities of 75 m/s within seconds. A honeycomb is located after the centrifugal fan in order to ensure flow uniformity. The cooling of the facility is achieved by the injection of pressurized liquid nitrogen through six spray nozzles located in the return circuit. When liquid nitrogen is injected at a pressure of 5bar, temperatures as low as -40°C can be reached at full speed. Without the use of nitrogen nozzles, the flow of the wind tunnel can be by-passed through a cooler enabling temperatures ranging from -10°C at low speed to +5°C at maximum speed. The temperature and the pressure in the wind tunnel are measured by a thermocouple and a pressure probe located at the beginning of the test section. In addition, a hygrometer registers the humidity inside the wind tunnel.

The CWT-1 has several water injection points upstream and downstream the test section. The water is injected into the wind tunnel with low pressure by a plain-orifice insulated nozzle and it breaks into droplets by the effect of the air velocity inside the wind tunnel. The diameter of the nozzle orifice can be selected according to the water flow that needs to be injected. Currently, the CWT-1 is able to operate with supercooled liquid droplets and mixed phase conditions. Further modifications aim at operating under glaciated conditions using a snow gun in the settling chamber.

Cold Wind Tunnel Scheme

- Minimum temperature; -40°C
- Maximum speed: 70m/s
- Maximum run time: 30 minutes
- LWC: 0.001-1g/m3 - MVD: 10um-300um
- 6 component balance
- Particle Image Velocimety
- High speed imaging
- Interferometric Laser Imaging and Droplets and Ice Crystal Sizing
- Global Rainbow Thermometry

Jeroen van Beeck
This email address is being protected from spambots. You need JavaScript enabled to view it.
Phone: +32 2 359 96 78